Here below SoloDL-ECU direct connection drawing and connection table. 4Ħ 3.1 Direct ECU connection SoloDL To connect SoloDL K line to Ducati 999R-999S ECU K line connect: pin 6 of the 7 pins right bottom connector of the logger to pin 16 of ECU Body connector (K line) and pin 7 of the 7 pins right bottom connector of the logger to GND pin of ECU Body connector (GND). AiM cable Body connector pin Pin function +Vb V CAN+ 20 CAN High CAN- Connect this cable to Ground 2ĥ 3 K Line connection The K line is only available on the following AiM devices: EVO4 SoloDL ECU Bridge The connection changes according to the device you are using moreover K line can be reached in two ways: directly on the ECU using Body connector through the AMP connector you find near the ECU The images here below show: ECU Body connector on the left and AMP connector on the right. Here below it is shown with its pinout and connection table. 1ģ 2.1 Direct ECU connection Ducati 999R and 999S ECU is equipped with two 38 pins male connectors they are named Engine (black) and Body (grey). Please note: when connecting your AiM device to the bike it is necessary to remove the 120 Ohm resistance that is mounted between CAN+ and CAN- in AiM device CAN cable otherwise Ducati dashboard will not work. 2 CAN bus connection The CAN Bus can be reached directly on the ECU or through the bike rear dashboard connector. Supported models and years are: Ducati 999R Ducati 999S Ducati 999R and 999S are equipped with a Marelli IAW 5.9 ECU that communicates with both the CAN bus and the K line, providing different information as explained in chapter 4. 1 AiM Infotech Ducati 999R and 999S Release 1.03Ģ 1 Bike years This tutorial describes how to connect AiM devices to Ducati 999R and 999S.
0 kommentar(er)
